Aluminium 6063 aluminium machining part Aluminium Kitchen Profile
|Product||Aluminium 6063 aluminium machining part Machined Aluminium Profiles|
|Material||Alloy 6060, 6061, 6063, etc.|
|Color||Different colors available (black, blue, green, champagne, bronze,
golden, vermillion, etc.)|
|Surface treatment||Mill finish, anodized, electrophoretic coating, powder coating,
thermal break, wood grain/wood-in-shift, etc.|
|Mould||Based on your drawing or use our mould free|
|Sample time||Usual practice: within 15 working days against payment|
|Usages||Windows, doors, curtain wall, solar panel, LED panel, heat sink,
|Certified||ISO9001-2008 Quality System,|
The problems of aluminum alloy doors and Windows and the problem
that should be paid attention
1: The production of aluminum doors and Windows shall be made in
the factory and shall not be made in the construction site.
2: The drainage hole in the sliding window of the sliding window
should follow the principle of the inner fan outside and outside,
to ensure the sealing performance of the doors and Windows,
especially the push-pull window of the horizontal bar.
3: Prior to the assembly of aluminum doors and Windows, it is
necessary to remove the masting of the end part, the end part and
the section of the section must adopt the sealing measures such as
waterproof glue to prevent the structure from seepage.
4: The structural assembly of the frame Windows must be made and
maintained indoors. It is necessary to remove dust, grease and
other dirt on the surface of glass and aluminum frame with solvent.
Every clean piece or piece of glass should be replaced with a clean
dry wipe. The solvent should be dumped on the cloth, and the cloth
shall be strictly prohibited. The glue must be full, no bubble, no
leak, the surface should be smooth and smooth. Glue adhesive must
not be reused.
Installation, product protection
1: Before installation to Windows and doors hole shape and position
accuracy of lofting, check the number and location of embedded
concrete meets the design requirements, the top window is connected
to the lightning protection zone, according to the rules for the
unqualified parts should supervise and urge the construction unit.
2: The oxide doors and Windows of cement mortar shall be embalmed
before the wall. In addition to the outer wall, the other surfaces
of the window frame are protected by adhesive tape or plastic belt.
No adhesive tape or plastic tape exists for the wall, so as to
avoid water seepage in the junction.
3: Adjust the positioning of the wooden wedge after the wall and
the window, and fix it with the nail, and not fix with the nails or
wooden wedge. The supervision unit (or the construction unit)
should be asked to make the acceptance record of the concealed work
before the joint, and the vertical, horizontal and diagonal lines
of the doors and Windows will be conducted
4: To clean and self-check the aluminum doors and Windows before
acceptance, and not to use any detergent that has a corrosive ratio
to aluminum profiles, glass and hardware accessories; The problem
should be rectification in time